The Leaded Bore From Hell...

Status
Not open for further replies.
MD, It looks like you're just going to have to trilobite the bullet and scrub it out.

Have you tried a Lewis/Hoppe's lead remover yet? I'm not sure if they make one for a 30 cal. But, with your machine shop you could whittle one down with a lathe.

On the Foul Out - it is working if you get approx. 1/4 volt with no load. It may go lower when set up in the bbl with solution, I didn't check that voltage.

It is very important that you have an oil/cleaning solution free barrel before you use the FO or you will get a false "clean" indication and it does nothing. Be sure to scrub the bbl out thoroughly with Outer's Crud Cutter or a similar degreaser.
 
We cleaned/degreased the bore with MEK prior to installing the Foul Out system.
Nada.

"trilobite the bullet..."
Very funny.

[This message has been edited by MAD DOG (edited February 21, 2000).]
 
The Lewis lead remover only goes down to.38 caliber, so that's out. The little cookie cut screen doodads they use can not be turned on a lathe, I would have to had grind them into submission.
 
Mad Dog,

It sounds to me that you have angered the gods of shooting regarding some past sins.

Is there something you wish to confess?
 
Danger... DANGER Topic is approaching critical byte mass.

STEP BACK FROM THE COMPUTER SCREEN

Lock and Load Part II????

------------------
Schmit
GySgt, USMC(Ret)
NRA Life, Lodge 1201-UOSSS
"Si vis Pacem Para Bellum"

[This message has been edited by Schmit (edited February 21, 2000).]
 
Status
Not open for further replies.
Back
Top