stagpanther
New member
I finally have started getting underway on my workshop project--no small feat since I had to start from the ground up with waterproofing the concrete and putting in the pegboard walls. The first two major toys to install are my shark CNC router on the left and my Prazipress on the right. The CNC router sits on a Kobalt table and the press is on a Craftsman table. The Kobalt table is only a bit more expensive than the Craftsman--but is vastly superior in stability, balance, quality of machining etc. Notice the ledge board I had to add to the back of the Craftsman table to keep it from tipping over. I still have to complete moving in all the reload components and tools which will probably take another week or so.