I made about 300 HPs today, and it took forever with the single cav.
I have never tried making more than a handful at a time before with the singles. I'm definitely dragging a chair out to the casting table the next time I decide to make a pile of these. (Straight isotope 95-2.5-2.5)
And I also made another 300 of these nifty little wadcutters (358432) for the wife's .38 while I was at it. It is a 358432 drilled for a HP pin, (this is actually the "Turtle Buster" mold that I posted here a few month ago) but for this run I put the flat pin in it but didn't pull it all the way down flush, so it left a nice concave nose on 'em instead of a deep hollow point. I kinda like the look.
I have never tried making more than a handful at a time before with the singles. I'm definitely dragging a chair out to the casting table the next time I decide to make a pile of these. (Straight isotope 95-2.5-2.5)
And I also made another 300 of these nifty little wadcutters (358432) for the wife's .38 while I was at it. It is a 358432 drilled for a HP pin, (this is actually the "Turtle Buster" mold that I posted here a few month ago) but for this run I put the flat pin in it but didn't pull it all the way down flush, so it left a nice concave nose on 'em instead of a deep hollow point. I kinda like the look.
Last edited: