tango1niner
New member
Any machinist or toolmaker worth his salt has all that is needed.
An 0"-1" outside mic and telescoping gages is all that is necessary.
Find a local machine shop, bring gas cylinder and op rod to them, get bore and piston sizes and verify they are not the problem.
Pretty simple and shouldn't take more than 20 minutes.
It's a place to start with no guessing...
Piston corners should be square and not rounded.
An 0"-1" outside mic and telescoping gages is all that is necessary.
Find a local machine shop, bring gas cylinder and op rod to them, get bore and piston sizes and verify they are not the problem.
Pretty simple and shouldn't take more than 20 minutes.
It's a place to start with no guessing...
Piston corners should be square and not rounded.
Last edited: