Loading Lever Comes Loose When Firing

Also, peening the pin- are you saying I should bend it slightly before re-inserting it to ensure it doesn't drift back out?
Click to expand...

There are probably any number of ways to do it. When mine was a little loose I tapped the end of the pin using a hammer and sharp center punch to flare the end enough to hold it. I did this using an anvil as a support.
 
Thanks MCB

I started a drafting and design technology course at Penn State in September of 1968 and did not flunk out until January of 1969. I have a record of academics which stands to this day.

Drinking beer was every bit as important then as it is now.
 
You must log in or register to reply here.
Back
Top