Lee loadmaster 30.06 full length resizing problem

Right on and thanks for the reply. Good luck on getting another press.

The only possible problem with the press that I can come up with is that the thickness of the shellplate may be excessive, thereby not allowing the sizing die to descend enough before contacting the shellplate.
 
Last edited:
Thanks. I ended up buying what my buddy used a lee turret, except I bought the classic. I ran some brass on it late last night with 100% success.
 
Sorry to chime in late... Not sure why the press would be the culprit--I have a hard time seeing it flex that much. Now it could have been the shellholder.


The other potential cause was that or your technique is different than your buddy's. If your cases are squeeling and dragging on the way out of the die, you are now pulling the shoulder FORWARD--lube issue.
 
No problem. I wasn't getting any squealing or anything. I actually hooked up the turret and follwed the same set us and I did on the loadmaster and the are sizing perfect.
 
You must log in or register to reply here.
Back
Top