DA trigger reach on CZ75s.

Pond, James Pond,

I'd give a call to Angus over to the CZ custom shop in Mesa, AZ. I think they will be well informed of what parts kits may be available as well as options for you.

A link to them here...

http://czcustom.com/

You could also check at the CZ forum.

The Beretta 92 is seen in the games so da/sa ain't uncommon but it's complicated by the longer reach for the CZ 75B trigger. So either that issue is resolved or you need another CZ.

CZ builds guns for a variety of competitive games.

tipoc
 
Assuming you have the standard black rubber grips, even changing out to something like VZ grips can make a huge difference for hopefully not a ton of money.
 
Or the Aluminum CZ grips which are even thinner, they basically run with the frame contour. Though they can be pricey i think i saw them for 65$ either at cajun or czcustom.
 
When I say Race Gun, I mean "my" race gun, rather than "a" race gun.

I run production category and stages start hammer down. If that is chamber loaded, then first shot is DA.

Aluminium grips are an option, certainly. Perhaps I should take my grips off and see what the reach is like with a bare frame.

CZ Custom: I can certainly call them, but I strongly suspect that they will have no options for me due to shipping constraints and a lack of knowledge surrounding EU stock.
 
i think it's something like 17". kind of tough to reach without some kind of mechanism or using your off hand to start the trigger pull. i've rigged up a trigger bar on mine similar to that of a bullpup rifle. it makes the trigger feel a bit mushy, but you get used to it.
 
Pond said:
When I say Race Gun, I mean "my" race gun, rather than "a" race gun.

I run production category and stages start hammer down. If that is chamber loaded, then first shot is DA.
Click to expand...
I missed that this is for competition. From the Cajun Gun Works page on the RRK:

Is it legal for shooting sports? No. The pre-travel set screw installed on the upper area of the trigger is visible. However, you can use the modified RRK disconnector w/o the upper trigger screw to noticeable reduce the DA stroke.
Click to expand...
I don't recall if it's the Cajun Gun Works site or the CZ Customs site, but one of them has a page detailing which countries they can send parts to.
 
Sorry Pond I did not grok where you were. Arizona may be dicey for you though an email to them could possibly turn up contacts closer to you. The fellas from CZ Custom get to Europe quite often and are familiar with smiths and resources from there.

tipoc
 
You must log in or register to reply here.
Back
Top