It's an older one from about the 1980s.
Sometimes the hammer will go back about 1/4"-5/16" and the trigger stops, won't go back any further. Shaking it or repetitive pulling on the trigger helps to get it going again.
While dry firing it often seems to stop on the same cylinder (but not always the same cylinder), and very rarely gets through three cylinders without getting stuck.
Any ideas as to what would cause this?
Sometimes the hammer will go back about 1/4"-5/16" and the trigger stops, won't go back any further. Shaking it or repetitive pulling on the trigger helps to get it going again.
While dry firing it often seems to stop on the same cylinder (but not always the same cylinder), and very rarely gets through three cylinders without getting stuck.
Any ideas as to what would cause this?
Last edited: