Camera for powder check

I tried an Android tablet today. A $50.00 7 " screen. I downloaded about 6 microscope viewing apps but none of them work. According to the " internet " Andriod stuff can be hit or miss. I'll try to find a known Android tablet that works.

Camera and stand alone monitor would be best.

Thanks for the info on " Quoting "

I mounted my Big Boss II today.

attachment.php
 

Attachments

  • IMG_2942.jpg
    IMG_2942.jpg
    205.5 KB · Views: 1,009
Nice camera system. I would love to have a 550 press and will snap one up if I ever see one at good used price. I learned how to reload on a 650. The powder check die the reason I went with the 650 over the 550.
 
Jim, what diameter drill bit did you use? Also, it looks as if the camera is held in place by the cross bar resting either on a die or the die holder itself, correct?
 
The camera measures 5/16 diameter.
A 5/15 hole was too small. A snug hole would be 21/64 . The second one I drilled was a tad bigger at 11/32.
Both work fine.
Securing the camera depends on which dies are in the plate. I'm sure a simple tie wrap will hold it in place. The camera measure 5/16 diameter.
I used a loom on one setup. Tie ties on a couple of others.
 
You must log in or register to reply here.
Back
Top