F flyboy015 New member Jun 14, 2017 #21 " It still shoots 1.5 MOA like it did when it was new." Nice! Did you use a set screw type GB or a clamp type, and how has it held up? My barrel will need just a little sanding / filing at the pins as well, GB almost slides right over.
" It still shoots 1.5 MOA like it did when it was new." Nice! Did you use a set screw type GB or a clamp type, and how has it held up? My barrel will need just a little sanding / filing at the pins as well, GB almost slides right over.
M Mobuck Moderator Jun 14, 2017 #22 "then cut upward just to the very bottom of the pins, smack said pins out with unnecessary fury." It really shouldn't take all that much "fury" but the impact should be in line with the pin to the best of your ability.
"then cut upward just to the very bottom of the pins, smack said pins out with unnecessary fury." It really shouldn't take all that much "fury" but the impact should be in line with the pin to the best of your ability.
B B-Shot New member Jun 14, 2017 #23 I used a set screw gas block, brand unknown reused the gas tube. No issues after 700rds or so.