Working on the thoery that you always modify the cheapest part my revolver is unmodified.
The cappers are slightly worked on, but it was only 4 minutes & I didn't use a dremel because by the time I'd unpacked & tooled up the thing I was done with an emery board!
All you need to do is slightly taper the ends of the brass so it fits into the existing cylinder cutouts.
The cappers are slightly worked on, but it was only 4 minutes & I didn't use a dremel because by the time I'd unpacked & tooled up the thing I was done with an emery board!
All you need to do is slightly taper the ends of the brass so it fits into the existing cylinder cutouts.