Wildman1960
Inactive
Anybody know where to get a trigger guard and screws for a Winchester 670, have exhausted all the usual parts houses, any suggestions will be appreciated.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Win 670
- Thread starter Wildman1960
- Start date
Wildman1960
Inactive
Thanks a million Doyle
Actually, the issue M670 stock will accept the Model 70 TG w/floorplate, magazine liner, etc.
IIRC, the follower & spring you now have should fit/work OK.
Just run a small drill(bit) down/out through all four corners of the blind magazine well, then cut out between the holes & clean up to get straight/tapering lines that match the M70 bottom metal.
The bottom of the stock just ahead & behind the new magazine opening will also need to be inletted for the bottom metal.
(I've added the upgrade to both Win 670's and old Rem 700 ADL's, both using new factory parts from the respective Parts Dept's)
.
IIRC, the follower & spring you now have should fit/work OK.
Just run a small drill(bit) down/out through all four corners of the blind magazine well, then cut out between the holes & clean up to get straight/tapering lines that match the M70 bottom metal.
The bottom of the stock just ahead & behind the new magazine opening will also need to be inletted for the bottom metal.
(I've added the upgrade to both Win 670's and old Rem 700 ADL's, both using new factory parts from the respective Parts Dept's)
.
It won't be cheap, but you can contact these guys
http://williamsfirearms.com/triggerguard.html
Found one here.
http://www.gunpartscorp.com/Products/1296220.htm
http://williamsfirearms.com/triggerguard.html
Found one here.
http://www.gunpartscorp.com/Products/1296220.htm
Last edited: