Who customizes grips?

0

0311

Inactive
Looking for someone to customize or should I say "thin down" some grips I have ordered that are kinda thick for my small hands! :confused:
 
Every set of wood (and some other materials) that I've owned in 54 years of shooting has been modified in some way, from refinishing to complete reshaping. "Thinning down some grips" leaves a lot of room for conjecture. Are they 1911 panels for old slabsides, finger grooved combats for a revolver...? This has gotten to be a "sub-hobby" - almost as pleasureable as reloading. You could probably do them yourself with little investment, and a good return in satisfaction. Plus, you will know when they are "right" for you, while the job is in process. Included in "all the grips" above, were a couple of sets made to my handprint by a very good man, and they still needed just a tad of personal attention.
 
Walosi, Sorry about not supplying enough info, but the grips are for a SA Champion model 1911 and made out of DuPont Corian, which is an imitation ivory, that I am looking at having "slimmed down" smaller than the regular 1/4 inch that they come in! I would do myself but the original grips that came on my 1911 didnt come out to good :confused: when I tried!! So now I would rather let someone (professional) have their hand at it!
 
The only maker I know of who works with Corian is Don Collins. He offers a fitting service on his own grips, and if these are not his, he might be willing to work them down. You can contact him through his site:

http://www.collinscraftgrips.com/

His work is as good as I have seen since my friend Deacon Deason left us.
 
Walosi, That is exactly where I am getting the grips from, but Don can only make them 1/4 inch thick. I just found out that the Corian material will warp if made any thinner so I guess I will be ordering some 1/4 inch thick Corian grips. Thanks for your reply though!:)
 
You must log in or register to reply here.
Back
Top