kilotanker22
New member
Anyone used these dies? The feature set is pretty attractive. Also for the price I would certainly hope that they are good quality
The link is in post #4.OK, I'll bite. Can anyone point me to a place to download printable versions of these incremental labels?
This is for 6.5 Creedmoor not .308Kilotanker22,
My mention of a .002" spread referred to an allowable range of case measurements. If the average shoulder setback is .002", that spread from. 003" to .001" is good.
Note your measurements are probably relative, not actual. A 308 Winchester GO headspace gauge is 1.630" . The Hornady gauge reference diameter of .400" is a few thousandths deeper in the gauge than the flat you zero it on. I've no idea why your 1.532" reading is in obtained as it's near a tenth of an inch off than I would expect. A reading about 1.62X" is what I would expect if the die touches the shellholder when sizing. The full length sizing die headspace is typically only .005" less than the GO headspace gauge 1.630" dimension.
Same thing applies with all rimless bottleneck cartridge. Only the basic numbers change; their relationship to each other is the same.This is for 6.5 Creedmoor not .308