S sunray Inactive Aug 22, 2005 #1 I need to check the gap between the cylinder and the barrel. It would be appreciated if sks could advise the nominal dimension, with a tolerance. regards Kenneth ==================
I need to check the gap between the cylinder and the barrel. It would be appreciated if sks could advise the nominal dimension, with a tolerance. regards Kenneth ==================
R radom New member Aug 26, 2005 #2 I really dont think they actualy payed much attention to that idea when they made the things, if it went bang it was in spec at the time.
I really dont think they actualy payed much attention to that idea when they made the things, if it went bang it was in spec at the time.
W Webleymkv New member Aug 28, 2005 #3 I'll take it off your hands if you decide you don't want to mess with it
