Taurus barrel swap?

I

imperative

New member
Hi there ...
How does one remove the barrel from the frame, and then install a new one? Is this a gunsmith job? I was think about trying out a shorter barrel, and was wondering if it was a big deal or not. The pistol in question is a .357 Model 669, IIRC.
Thanks!
 
This is a gunsmith job. Special wrenches and a vices designed to fit the barrel and frame are required. A new barrel will, of course, be needed. You might be well advised to check the cost of such a project and compare that to the cost of buying another gun.
 
In addition to what stans said you will likely also need to adjust the shank to the correct cylinder gap and so that the sight and extractor shroud are indexed correctly. This requires a lathe. In my shop the job would run $90 plus the barrel. You might check around and see what others are charging. I think I'm about average. George
 
You must log in or register to reply here.
Back
Top