chris in va
New member
Could you measure your factory rubber grips? I'd like to find out if they would fit my 97b, even with a slight gap toward the front.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
SP01 owners, a question
- Thread starter chris in va
- Start date
chris in va
New member
Mainly width and length. I think it might (sorta) fit on my 97b, just wondering how much gap I'll have to accept.
I fitted the factory plastic 75b grip on it and there was some 'daylight' showing from inside the frame toward the front strap.
Basically just trying to find grips with the 'coke bottle' profile. CZ in their infinite wisdom decided to make the grips flat on the 97.
I fitted the factory plastic 75b grip on it and there was some 'daylight' showing from inside the frame toward the front strap.
Basically just trying to find grips with the 'coke bottle' profile. CZ in their infinite wisdom decided to make the grips flat on the 97.
Last edited:
Width across bevel at the top: 1"
Width across top flare: 1 3/8"
Width at screw: 1 1/2"
Width at CZ log: 1 1/2"
Width at very bottom: 1 3/8"
Length across mid-line of grip: 3 3/4"
Of course, I may be off a bit here and there, but the above should be within 1/8th of an inch, probably more like a 1/16 margin of error.
(SP-01, standard/base model)
Width across top flare: 1 3/8"
Width at screw: 1 1/2"
Width at CZ log: 1 1/2"
Width at very bottom: 1 3/8"
Length across mid-line of grip: 3 3/4"
Of course, I may be off a bit here and there, but the above should be within 1/8th of an inch, probably more like a 1/16 margin of error.
(SP-01, standard/base model)
chris in va
New member
Thank you very much!