myfriendis410
New member
I've got a new P232 that won't come apart for cleaning with the takedown lever engaged. Any thoughts before it goes back to Sig Sauer?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Sig P232 disassembly problem
- Thread starter myfriendis410
- Start date
Send back to Sig? Try learning from YouTube. This is what I found:
http://www.youtube.com/watch?v=IIoRBKpwLR4
http://www.youtube.com/watch?v=IIoRBKpwLR4
myfriendis410
New member
Yeah; the gun is empty and no mag. When you pull the slide back after rotating the takedown lever to the "remove" position you get absolutely no indication of a point where the slide will lift. I applied a considerable amount of pressure and even rotated the takedown lever back and forth while the slide was back; no go.
The first thing I did was look at the Youtube video.
The first thing I did was look at the Youtube video.
myfriendis410
New member
That was done. The disassembly procedure was followed precisely and it will not go. Right out of the instruction manual and the Youtube video. The takedown lever rotates and you can see it rotate on the off side so it's not sheared off.
It appears the gun will have to go back to Sig.
It appears the gun will have to go back to Sig.
myfriendis410
New member
The customer took it home when he picked it up. It has never been apart. Nobody, including the seller, can GET it apart.
Once again: as far as I know, THE GUN HAS NEVER COME APART SINCE IT SHIPPED FROM THE FACTORY.
So I repeat my question; any constructive advice for disassembly or is this going back to Sig?
Once again: as far as I know, THE GUN HAS NEVER COME APART SINCE IT SHIPPED FROM THE FACTORY.
So I repeat my question; any constructive advice for disassembly or is this going back to Sig?