First time I ever had this experience. I have a Leupold 6.5-20 on a .270 WSM and I was sighting in at 100 yards using 10 power. Shots were 1.5" high, slightly off to the right. I cranked up to 20 power and fired at 200 yards; I hit about 4" to the right. At 300 yards I was about 9 inches to the right. Wind was not an issue and I set the yardage to adjust for paralax at the corresponding location on the optical end. I reset the scope to 10 power and I hit dead on at 300 yards (adjusting for distance, of course). Should I send the scope back to Leupold?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Scope changing point of impact
- Thread starter cdoc42
- Start date
I would check the mounts and rings then check to see if the scope is properly aligned with your rifle. Something may have come loose or got bumped . After you have checked all that go back to the 100yd target test fire and adjust the windage. Remember that if your shooting say 2" to the right @ 100yds, you would be 4" to the right @ 200yds and 6" to the right at 300yds etc. From the information in your post it sounds like your getting farther off to the right as the range is increased. Then again, it might be the scope . Not to worry Leupold has a great warranty
Good luck
Rich
Good luck
Rich
You probably already know this... but
a little bit to the right at 100 yards will look pretty drastic at 200 and subsequently greater at 300 yards.
If that isn't the problem...
And the scope is wandering around (Back and forth and or up and down)
Send the scope back to Leupold...
Call them first and get a return authorization code...
a little bit to the right at 100 yards will look pretty drastic at 200 and subsequently greater at 300 yards.
If that isn't the problem...
And the scope is wandering around (Back and forth and or up and down)
Send the scope back to Leupold...
Call them first and get a return authorization code...
Thanks to both of you. I'm not surprised by the additional travel as the yardage increases. MAybe I didn't explain it clearly enough. What IS surprising is when I dropped the power down to 10 the point of impact at 300 yards was the same as that seen at 100 yards (adjusted for elevation).
For example, at 10 power, at 100 yards my point of impact was 1.5 inches high, about 1 inch to the right. At 300 yards it was 1 inch to the right and 6 inches low. Just what I would expect.
When I increased the power to 20, at 300 yards I was 6 inches low, but 9 inches to the right.
I fired 3 shots in all cases so the above changes were consistent. None of the scopes on my other rifles do that ( Burris and Bushnell).
I tried to e-mail Leupold but so far I've not had a response.
For example, at 10 power, at 100 yards my point of impact was 1.5 inches high, about 1 inch to the right. At 300 yards it was 1 inch to the right and 6 inches low. Just what I would expect.
When I increased the power to 20, at 300 yards I was 6 inches low, but 9 inches to the right.
I fired 3 shots in all cases so the above changes were consistent. None of the scopes on my other rifles do that ( Burris and Bushnell).
I tried to e-mail Leupold but so far I've not had a response.