HisSoldier
New member
Got an old clackity clack given to me, and having spent much time and money so far I have it to where it fires 2 out of 10 rounds without help. I finally looked at the feed ramp on the barrel and saw gouges in it.
So I punched the pins out to remove the barrel, and polished that ramp.
But in the process of removing the barrel the bumper fell out and went into hiding immediately, much time on my hands and knees later I found it, not on the floor but higher on a shelf! (I'm thankful to have found it at all, making a new one would mean heat treating W-1 by the looks of it, and it's hard to make a part without a sample)
But I knew there was a spring somewhere that holds the bumper down, and I think I found it too, on the bench.
But I can't figure out where it fits! Anyone know?
Thanks,
So I punched the pins out to remove the barrel, and polished that ramp.
But in the process of removing the barrel the bumper fell out and went into hiding immediately, much time on my hands and knees later I found it, not on the floor but higher on a shelf! (I'm thankful to have found it at all, making a new one would mean heat treating W-1 by the looks of it, and it's hard to make a part without a sample)
But I knew there was a spring somewhere that holds the bumper down, and I think I found it too, on the bench.
But I can't figure out where it fits! Anyone know?
Thanks,