TrueBlue711
New member
I'm just about done with this install. I finished the trigger and everything in the frame. Now, I'm trying to replace the plunger that is under the rear sight in the slide. Took out the set screw in the sight, put it in the vice (non-marring) and trying to tap it out using the sight removal punch included with the trigger. But it's not budging! When I watched a video of the install, the sight just slid out. I even tried heating it up with a small torch. Still not budging. I'm on the edge of taking it to a smith, but would rather avoid the hassle and $$ for just removing the rear sight. Any ideas?