Ruger sr9 fluff and buff and trigger bar

L

lonewolf5348

New member
I like to ask any one here install the ghost trigger bar the ultimate series in there SR9 if so what was your outcome ?
I have the new gen: sr9 seem the newer style has a improve striker cap only need to depress the striker to slide the cap out.
I would like to get the trigger poundage down a little now from the factory it breaks at 5 lbs
I hate to buy the ghost bar and see no results?
I did fluff and buff internals but would like to take the trigger to another level.
 
I bought the kit with intentions of doing it myself, but after going through the instructional materials on site decided my skills weren't up to it -- I have a knack for dropping or misplacing small important parts and springs, etc., and the SR9 action has an abundance of small parts and springs. Many folks in the area have done it themselves without problems.

I had my gunsmith do it, using a print out of their website instructions. He said the instructions were pretty good, but were not QUITE as detailed as the gun parts. :)

With the parts installed, the trigger is still heavier than I like, but the trigger is now crisp, without grunge... I'd still like it a little lighter. I also have an SR9c, and that trigger is fine -- lighter, but less crisp than the SR9.
 
I did install the ghost trigger bar the ultimate series in there SR9
out come :
I feel improvement on take up fire a lot faster
weight: I still think maybe 1/2 lbs Gain would say still in the high end 4 lbs range.
I would return it for a refund but them little springs are a pain in the butt in the gun it stays.
not worth the 20.00 bucks
 
You must log in or register to reply here.
Back
Top