JAMES L.SMITH
New member
I NEED TO KNOW HOW LONG THE HAMMER PLUNGER IS SUPPOSED TO BE? THANKYOU
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
RUGER SINGLE SIX
- Thread starter JAMES L.SMITH
- Start date
George Stringer
Staff Alumnus
James, I don't have that info nor do I have one in the shop to measure. If you're intending to make one, Gun Parts Corporation www.gunpartscorp.com lists them for $1.15, and Brownells www.brownells.com list them for $1.84. George
JAMES L.SMITH
New member
<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by TomD:
I just put one back togeather and read this. George is right it'd be a ho lot easier to order one. Let me know if you just need the dimension and Ill pull it out measure it for you. If your going to try and make one you'll need more than the length. Let me know[/quote]
I just put one back togeather and read this. George is right it'd be a ho lot easier to order one. Let me know if you just need the dimension and Ill pull it out measure it for you. If your going to try and make one you'll need more than the length. Let me know[/quote]
Having put both sweat and blood (and maybe some tears) into making parts that could not be obtained, I don't understand why anyone would want to make a part that can be bought for a couple of bucks. Is it the challenge, or do folks not know that parts are available, or they don't know how hard it can be, or is it some American determination to "do it yourself"? Beats the heck out of me.
Jim
Jim
JAMES L.SMITH
New member
hey guys i did not want to make the plunger pin.just size the one i bought from Brownells,the new one was way too long.i trimmed the new one a tab tooo much.just wanted to know if anyone had correct measurement.Thanks