I need some help with ruger rings. I was looking for a new scope with a 50mm objective and found the following:
-The front integral base is higher the then rear
- rings are sold separately, and only by height not front and rear
- using match pairs (rings of the same height) would create an upward slant when mounted
This would seem to place stress on the tube. I have at least low mount and medium, maybe high. I have to match up the measurements to the ruger chart. I believe the second set is .57, which would make it high.
-The front integral base is higher the then rear
- rings are sold separately, and only by height not front and rear
- using match pairs (rings of the same height) would create an upward slant when mounted
This would seem to place stress on the tube. I have at least low mount and medium, maybe high. I have to match up the measurements to the ruger chart. I believe the second set is .57, which would make it high.