Wreck-n-Crew
New member
I just finished a casting session of 4 calibers and 3 are fine but I found a problem with the 9mm's...Rookie mistake evidently. I found it during sizing. Many of them were not going through the sizer. Had to beat a couple out...not good!
Anyhow I did a check on the diameter at the beginning of my session to be sure they were dropping the right size and i didn't check on it again, bad mistake as it turns out! There out of round!
These are the same bullet.
Man if only I would have held up My mold and checked the daylight every now and then I wouldn't have to redo the whole batch (about 1600)! Good news is the molds are fine. Got the gunk out of the alignment pin on the far side of the mold and it is closing all the way now.
Anyhow I did a check on the diameter at the beginning of my session to be sure they were dropping the right size and i didn't check on it again, bad mistake as it turns out! There out of round!
These are the same bullet.
Man if only I would have held up My mold and checked the daylight every now and then I wouldn't have to redo the whole batch (about 1600)! Good news is the molds are fine. Got the gunk out of the alignment pin on the far side of the mold and it is closing all the way now.