? replacing front sight CZ75BD

S

shootsafe

New member
I am going to try to replace the front sight on my CZ75BD, with the dovetail that looks like a pinned front sight.

Any advice on how to remove this pin and the factory sight.

If I need to drill the new sight, what is the bit size?

Thanks,
Shootsafe
 
If it looks like this one, use a pin punch that'll just fit the hole, drive the roll pin almost all the way out (far enough to release the sight) and swap sights. If you're real lucky, the hole in the sight will line up with the hole in the slide.

Tap the roll pin back in and you're all set. Assuming the new sight is the right height, of course!

CZ75Aredbackground.jpg
 
Thank you

So, you think the front sight will already be drilled?

I am going to install the TTF Series from Precision Sales International TTF86CZ.

Thanks,
Shootsafe
 
Japle, if that CZ is yours, where did you find or what did yo have done to your trigger?

I have been trying to find something that will shorten the pull a bit as the reach is a tad too long for me to have a proper grip and fire the gun fully decocked in DA mode. At half-cock it is better, and, of course, fully cocked in SA mode I have no problems with reach.

I guess I should ask, does that trigger actually shorten the length of pull?
 
You must log in or register to reply here.
Back
Top