9ballbilly
New member
I'd like to remove the magazine disconnect on my FN Hi-power 9mm.
I watched what videos I could find and it looked like a simple job of punching out the pin in the trigger, moving the upright bar (part of the transfer bar system?) to the rear, and pushing out the disconnect.
No problem following the steps except the disconnect was not free for removal. I coated it with WD-40 thinking crud might be holding it in place, but still no dice.
It seems like I missed a step somewhere along the line. Any help would be appreciated. My gun was produced in 1989 BTW.
Thanks
I watched what videos I could find and it looked like a simple job of punching out the pin in the trigger, moving the upright bar (part of the transfer bar system?) to the rear, and pushing out the disconnect.
No problem following the steps except the disconnect was not free for removal. I coated it with WD-40 thinking crud might be holding it in place, but still no dice.
It seems like I missed a step somewhere along the line. Any help would be appreciated. My gun was produced in 1989 BTW.
Thanks