Hello,
I was curious if anyone knows the grade of glass bead to match the factory finsh of the stainless 700s? I know its probably between medium or medium fine(80 -120?) but not sure exactly. Trying to touch up a 5r stainless and a few others but all seem to have the same finish. Will any brand work or do I need a specific band of bead to match. Had to buff a scratch out on the reciever and it got polished up. Also a mark on the bottom of reciever from the bedding block rubbing and mark on the bolt need a touch up blast I think. May do a bit on two other 700s as well. Likely wouldn't need 50 lbs I think, maybe <25 tops?
So just a small blast to blend is what im after. Never done this before so trying to find a abrasive blaster for air compressor etc. Also what PSI and distance away do I need to do?
Thank you
I was curious if anyone knows the grade of glass bead to match the factory finsh of the stainless 700s? I know its probably between medium or medium fine(80 -120?) but not sure exactly. Trying to touch up a 5r stainless and a few others but all seem to have the same finish. Will any brand work or do I need a specific band of bead to match. Had to buff a scratch out on the reciever and it got polished up. Also a mark on the bottom of reciever from the bedding block rubbing and mark on the bolt need a touch up blast I think. May do a bit on two other 700s as well. Likely wouldn't need 50 lbs I think, maybe <25 tops?
So just a small blast to blend is what im after. Never done this before so trying to find a abrasive blaster for air compressor etc. Also what PSI and distance away do I need to do?
Thank you