Refinishing 8mm Mauser

T

tliebs

Inactive
Hello All,

I just purchased (2) K98 Mausers yesterday. Both are in pretty decent shape, but I would like to sporterize one and refinish the other to get ugly out of the finish.

I am sure there are many here who have done this type of work so I am looking for guidance and links that might go over the process in depth. I do not have a great deal of gunsmithing experience. Nor do I have a great deal of equipment to work with. However, I do follow directions well and I am also willing to pay for work to be done that I would not be comfortable doing myself.

Also, if anyone can recommend a reliable gunsmith to do trigger work as well as refinishing barrels, that too would be greatly appreciated.

Thanks to all in advance for the replies!
 
Find out what you have before......

You start choping and chaneling. Either one might have significant value. I know only too well the siren's call to improve it for sporting use. Back in the '60'sand '70's I did more than a few, but now it doesn't make sense from an economic standpoint. I have a nice 1917 Enfield in a wildcat, heavy barrel and all the bells and whistles. Also a 98K sported that someone spent tons on. I bought both used and let someone else take the hit. Folks now are into replacing issue stocks if the metel hasn't been twicked with. This is America and thank God you still can do whatever you want to you're own property..........Essex
 
Refinishing may cost alot as you would have to make a large investment in gear to do a gunsmith type job. You can always do cold blue touchup work and the like. Some have even gone and stripped and redone the whole gun with cold blue, I have never tried that. And it is not always a super durable finish. One of the spray on poly. finishes might be a way to go, I have not done that either. You can figure out ways to reduce your gunsmithing costs though. If you can disassemble and prep the gun and parts for finishing, that will save the smith alot of time, and you, money. That probably means detail stripping and either stripping down to bare metal and polishing it yourself, or accepting a dull bead blasted finish on the gun. The smith can bead blast a gun down to bare metal alot easier than stripping and polishing=saved money. Then you get a matte blue or perhaps black parkerised finish in the end. You can buy and fit your own sporter stock to the Mauser after it is finished. I might let the gunsmith drill for scope mounts, if wanted, unless you are a machinist or skilled. Rebarreling and chambering is not cheaply done at home either. DIY sporterising is not the most economical way to get a new nice gun nowadays, usually, but there are books from Brownells and the like that can get you started if you are that ambitious. Good luck! Edit-you can get aftermarket adjustable triggers for Mausers and install them yourself, as a trigger job on the original military trigger is of doubtful usefulness, but a little polishing can smooth it up a bit.
 
You must log in or register to reply here.
Back
Top