Red Dot Problem

C

cohoskip

New member
In order to do some work on my Buckmark I removed the Burris Trophy red dot scope. When I put it back on the image was very blurry.
Tapping gently had no effect so I removed it again. The next day I picked it up and the image was crystal clear, so I remounted it. Again the image was very blurry. I removed it again and set it aside. This morning I looked at it and the image was still a little fuzzy, but not as bad as when I removed it.
I have had, and used, this scope for 2 or 3 years with no problems.
:confused::confused:
 
Check the dial to make sure it's centered on a power level number? Same for the reticle dial (if the model has multiple reticles)?

Sounds like something is being pushed out of alignment, possibly when you tighten down the mount.
 
You must log in or register to reply here.
Back
Top