TruthTellers
New member
I have a SAA clone in .32. The gun shoots about 6 inches high at 15 yards, which is excessive to me. To get it closer to the POI, I have to raise the front sight or file down the rear sight, which I am not going to do.
I'm trying to think of ways to add material to the top of the front blade sight and so far I'm coming up with two options:
1. Find some black plastic, form it to the contour of the front sight, and glue it on. Then, file down to the desired height to get POA to the POI.
2. Drill and tap a very small hole on the .062" wide sight and run a screw/bolt into the hole, loctite it in place, and file down to desired height.
What ideas do you folks have that might be better?
I'm trying to think of ways to add material to the top of the front blade sight and so far I'm coming up with two options:
1. Find some black plastic, form it to the contour of the front sight, and glue it on. Then, file down to the desired height to get POA to the POI.
2. Drill and tap a very small hole on the .062" wide sight and run a screw/bolt into the hole, loctite it in place, and file down to desired height.
What ideas do you folks have that might be better?