So I was on gunbroker.com the other night which is almost always a bad thing. I was looking for a M70 stock to dress up my .375 Ruger I built on a push feed 7mm Mag XTR years ago. The main reason I am looking for a stock is my rifle had a wide target forend on it.
I tried reshaping the stock, and while I didn't ruin it I made it hard to grip during recoil. I made the sides a little to flat and verticle, after trying to quickly remove material on a bench mounted sander. Sometimes we learn things the hard way in an attempt to save money.
I came across a factory unfinished M70 Supergrade Safari stock with less than an hour on the auction. I threw up a bid and then drove to work. I got the notification I won the stock the next morning after getting off work and turning my phone back on.
So I pay for the stock and look at the pictures as I have more time. The grain through the wrist area of the stock was something I had missed. I'm by no means an expert on stocks, but I seem to remember wanting straight grain through the grip and wrist area.
So I'm wondering if I should be concerned about this stock on my .375 Ruger? If so would having a pin installed in that area be a good idea? I'm going to have a professional do the work this time.
I tried reshaping the stock, and while I didn't ruin it I made it hard to grip during recoil. I made the sides a little to flat and verticle, after trying to quickly remove material on a bench mounted sander. Sometimes we learn things the hard way in an attempt to save money.
I came across a factory unfinished M70 Supergrade Safari stock with less than an hour on the auction. I threw up a bid and then drove to work. I got the notification I won the stock the next morning after getting off work and turning my phone back on.
So I pay for the stock and look at the pictures as I have more time. The grain through the wrist area of the stock was something I had missed. I'm by no means an expert on stocks, but I seem to remember wanting straight grain through the grip and wrist area.
So I'm wondering if I should be concerned about this stock on my .375 Ruger? If so would having a pin installed in that area be a good idea? I'm going to have a professional do the work this time.
Last edited: