Problem with scope on S&W .460 Perf. Ctr.

T

Theojt

Inactive
Hi,

I am using the factory-provided scope base and Warne 1" Maxima permanent rings to mount a Nikon 2.5-8 Monarch. To get the scope aligned anything close to point of impact, I have to rotate the windage all the way to the left (fully clockwise). I'm out of the adjustment range on the scope and still not where I need to be.

I tried moving the rings - swapping the side that they fasten from in various configurations but no change. I think the base only goes on one way, Any idea's what could going on or how to find out?

Jeff
 
This shouldn't be too hard to figure out. Get one of the inexpensive laser bore sighters and put it in the barrel and try to adjust the scope to make the cross hairs cover the light point. Assuming they won't, pull the scope out of the rings and close the rings back up and set the gun upright in a gun vice or in a cardboard box that you've cut notches in to hold the gun upright. Then step back and see if the laser spot is centered in the rings? You can also hang a weighted string down a wall and open the cylinder and use a dental mirror to see where the barrel is actually looking, left to right? Adjust the vice or box that is holding the gun to get the string centered in that view down the tube. Then look through the rings as before to see if they are centered, too? You may even want to pick up a straight length of tubing to cradle in the lower ring halves to help check alignment by sighting through it?

If the barrel and rings line up, the scope has a problem. If they don't, the rings are incorrectly placed or aligned or machined. If they are right, the base is incorrectly placed or aligned or machined. It could require a return to the factory in that instance.
 
Thanks - I'll try these suggestions. I do have a laser boresighter- that's how I originally identified the problem (later verified at the range).

Jeff
 
You must log in or register to reply here.
Back
Top