Pressure Switch Mounting
- Thread starter HankL
- Start date
cntryboy1289
New member
velcro
The simplest method is to use velcro wrapped around the attachment point. I have seen some even use tape as well.
The simplest method is to use velcro wrapped around the attachment point. I have seen some even use tape as well.
Use tire innertube
A bike tire innertube is great. Take an innertube and cut a cross section the length you need to cover up the switch. Stretch it out as you slip it over the barrel, sight and onto the handguards in the case of an AR-15. It will hold much tighter than velcro.
Good Luck
A bike tire innertube is great. Take an innertube and cut a cross section the length you need to cover up the switch. Stretch it out as you slip it over the barrel, sight and onto the handguards in the case of an AR-15. It will hold much tighter than velcro.
Good Luck
fishcapt007
Inactive
Heat Shrink!
A few questions if I may.
cntryboy1289, Are you wrapping the attachment points with the type of
velcro that sticks to itself and attaching the proper type of velcro to the
switch in some manner?
Lazy D, Once you install these innertube bands over the switch doesn't the
pressure turn the switch on?
fishcapt007, If you were to use heat shrink you would either have to cut it
off or remove the light/lazer from the firearm at every battery change.
cntryboy1289, Are you wrapping the attachment points with the type of
velcro that sticks to itself and attaching the proper type of velcro to the
switch in some manner?
Lazy D, Once you install these innertube bands over the switch doesn't the
pressure turn the switch on?
fishcapt007, If you were to use heat shrink you would either have to cut it
off or remove the light/lazer from the firearm at every battery change.
cntryboy1289
New member
more info
yes, I use the kind that sticks to itself. All it takes is one wrap around and it holds the pressure switch in position and you can easily activate it.
yes, I use the kind that sticks to itself. All it takes is one wrap around and it holds the pressure switch in position and you can easily activate it.