Powder die resizing neck, problem

[Machineguntony]

I'm reloading 223 on a Dillon 1050.

In station 2, I'm using a Lyman M die. But then when the case gets to the charging station, the powder die then resizes the case neck back down, thus defeating the purpose of the M die.

The station after the powder die, I have a Mr Bulletfeeder. And the bullets are falling off the case because the the powder die is resizing the case neck.

How do you guys solve this problem? I have no idea how to prevent the powder die from resizing the neck.

 

[Machineguntony]

Ok. So no more than ten minutes after posting this, fried calls me up from seeing this post and says my powder die, the piece inside, is probably upside down. Sure enough.

Solved the problem.