straight-shooter
New member
I have a idea and thought I'd throw it out here and get some opinions. Keeping rifle bullets standing up during powder coating and transferring them to the oven and back out has been a problem. I may have a easy solution.
Hopefully I can explain this clearly and paint a picture since I haven't actually made this contraption.
Take a flat metal pan and drill a hole on each side across from each other and install a screw in both holes. Line the bullets in a straight line between the two screws. Wrap a wire around one screw and then in a straight line to the other screw and at the same time put the wire into the lube grooves of the bullets, now wrap the wire again around the opposite screw and back the other direction. Simple enough to hold the bullets to make moving them easier.
Here's a rough drawing to give you an idea...
Hopefully I can explain this clearly and paint a picture since I haven't actually made this contraption.
Take a flat metal pan and drill a hole on each side across from each other and install a screw in both holes. Line the bullets in a straight line between the two screws. Wrap a wire around one screw and then in a straight line to the other screw and at the same time put the wire into the lube grooves of the bullets, now wrap the wire again around the opposite screw and back the other direction. Simple enough to hold the bullets to make moving them easier.
Here's a rough drawing to give you an idea...