I want to put a peep sight on a Win 9422 that is ungodly accurate and I want more.
Anybody know which front sight height to order from Brownell's?
If u can figure better than me, here are the measurements.
Height of receiver over barrel = .046"
Barrel dia at rear .716" at muzzle .5925
soooo...figgerin diff of 1/2 of each of those, the diff is .062" for barrel taper.
Is that right?
Now the ramp from bottom of ramp to bottom of dovetail is .204"
Brownells says that the Williams grooved receiver sight FP-GR is appx 3/8" from top of receiver.
The front I want to use is the Lyman globe target type 17A.
The choices are .404", .465", .494", .584" and .854.
Those heights are from dovetail bottom to center of globe.
I seem to have lost myself in subtracting the ramp height from the barrel taper and now can't figure where to measure from.
Anybody know which front sight height to order from Brownell's?
If u can figure better than me, here are the measurements.
Height of receiver over barrel = .046"
Barrel dia at rear .716" at muzzle .5925
soooo...figgerin diff of 1/2 of each of those, the diff is .062" for barrel taper.
Is that right?
Now the ramp from bottom of ramp to bottom of dovetail is .204"
Brownells says that the Williams grooved receiver sight FP-GR is appx 3/8" from top of receiver.
The front I want to use is the Lyman globe target type 17A.
The choices are .404", .465", .494", .584" and .854.
Those heights are from dovetail bottom to center of globe.
I seem to have lost myself in subtracting the ramp height from the barrel taper and now can't figure where to measure from.