I have a new 7600 and the trigger pull is 4.5 -5 lbs I would like it at 2.5-3.5 lbs. I found the sear spring kit online it will cost $15 to ship and am more than capable of installing it. A trigger job seems to be between $50-150 shipped. Most of them involve replacing or reshaping the sear in some way. I was wondering if the kit would help and if sear or sear spring was more important to trigger pull.
Patriot sear spring kit from Barnes or pro trigger job for Remington 7600
- Thread starter Zmax
- Start date
The Patriot Spring does indeed make for a better trigger as far as pull weight goes ! There will still be some creep but I don't find that to be a big deal on a hunting rifle ! If you decide to have it worked , make sure you get a Smith with some experience . I just fixed one somebody had screwed up bad , it would fire if you just tapped the butt on the floor . A new Hammer and sear spring made it right again . I kept the Sear Spring that had been installed to show people what they don't want , Hammer too . Trigger pull was less than a # ! I used to use the Patriot Spring but now I make my own . much cheaper !
Keep you finger out of the trigger till your sight are on target !!
Yes, spring kit and honing will do wonders. Initially just honed and it made a difference. Went back later and did the spring kit and perhaps might have gotten too light for a hunter. Very easy to do. ....
Be Safe !!!
Yes, spring kit and honing will do wonders. Initially just honed and it made a difference. Went back later and did the spring kit and perhaps might have gotten too light for a hunter. Very easy to do. ....
Be Safe !!!