Out of Round

D

Dean C

New member
My son and I recently purchased two Ruger M77's chambered for .270 WIN. Fired them for the first time yesterday. (WOW SWEEEEET) When I examined the neck of the spent shell, I noticed that one of the rifles left the neck with a flattened area while the other left the neck near perfectly round. First question: Is that normal? Second question: Will that effect accuracy?
dean
 
I'd strongly suspect the case neck was being dented when it was extracted and ejected. This is fairly common.

Shoot the rifle again, carefully open the bolt, and remove the casing by hand before it can fully extract on it's own.

If the case head is still out of round, have it looked at by a gunsmith, or contact Ruger.
 
Dfariswheel,
As usual, you are correct. My mentor! Took a couple out slowly, round. Took a couple out with normal action, small flat spot.

Oh, "by the way" (I don't use TLA's) it was my son's rifle and he shoot's about a 3" pattern at 100 yd. off hand. (He's good).

thanks again Dfariswheel,
dean
 
You must log in or register to reply here.
Back
Top