madcratebuilder
New member
Two new revolvers at my house, both from board members.
SainthoodDenied supplied this Uberti Whitneyville Dragoon. This has been on the list for a while, I was hoping to find it as a 3rd gen but this was just to nice to pass up. One week later I found the 3rd gen, never fails! This is the best Uberti I have owned, much better than the earlier builds I have had.
The second revolver is a Dance Bros Confederate Texas Colt clone, supplied by MJN77. These are somewhat hard to find, made by Pietta, two version that I'm aware of and I believe there may be a third that is a rare find. What makes these unusual is the flat sided frame, no recoil shield like you find on a regular Colt. Typical round barrel found on most the 51 Navy Confederate copies. A very few of the originals had a full recoil shield.
A big thanks to both members for selling these beauties.
SainthoodDenied supplied this Uberti Whitneyville Dragoon. This has been on the list for a while, I was hoping to find it as a 3rd gen but this was just to nice to pass up. One week later I found the 3rd gen, never fails! This is the best Uberti I have owned, much better than the earlier builds I have had.
The second revolver is a Dance Bros Confederate Texas Colt clone, supplied by MJN77. These are somewhat hard to find, made by Pietta, two version that I'm aware of and I believe there may be a third that is a rare find. What makes these unusual is the flat sided frame, no recoil shield like you find on a regular Colt. Typical round barrel found on most the 51 Navy Confederate copies. A very few of the originals had a full recoil shield.
A big thanks to both members for selling these beauties.
