I recently received a new hardchromed slide back from Kel Tec for my P32. I did not send in the original guide rod and recoil spring, but when I got the slide, barrel, etc. back, they had included a new rod and spring.
Here's the problem. The new spring is approximately 4 coils longer than the original that was shipped with the gun (serial # 12XXX). It is, of course, much stiffer and harder to install. Which of these springs do you folks think I should use. Haven't fired it yet. I'm going to wait until I get input here.
Thx!
SG
------------------
The people's good is the highest law -- Cicero
Here's the problem. The new spring is approximately 4 coils longer than the original that was shipped with the gun (serial # 12XXX). It is, of course, much stiffer and harder to install. Which of these springs do you folks think I should use. Haven't fired it yet. I'm going to wait until I get input here.
Thx!
SG
------------------
The people's good is the highest law -- Cicero