I bought a fobus holster for my P22. I have been practicing drawing, but have had no luck in removing the pistol from the holster. I've have tried the snappy movement as suggested in the instructions (i finally gave in and read them) with no luck. Everytime I just end up lifting my belt or pants up. There is no tension screw on the holster. Does anyone have any ideas?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Need help with Fobus holster
- Thread starter Pecos21
- Start date
f8lranger4x4
New member
I have one for my M9 Beretta and it is quite hard to get it out. I have found a slight twist while pulling will do the job.
TacticalJunkie.com
Inactive
RE: Holster problems
Once you break the holster in, it tends to get easier. I have one for my 1911 and it was hard at the beginning but it worked in. However if this does not work, I would recommend the sandpaper. If your uncomfortable with this method, try contacting fobus they have some great customer service.
Once you break the holster in, it tends to get easier. I have one for my 1911 and it was hard at the beginning but it worked in. However if this does not work, I would recommend the sandpaper. If your uncomfortable with this method, try contacting fobus they have some great customer service.
silicon wolverine
New member
+1 on armor all. also fobus rigs take awile to break in. Ive had mine for my G17 about three years now and its just getting to where i like it the best.
SW
SW