I recently bought an 1895 Nagant revolver. The brass seals the cylinder/barrel gap effectively so a form 1 silencer is the next logical accessary to add. I was considering making a wipe type silencer like the original bramit device, but I think that replacing wipes every dozen rounds is a pain in the butt.
I can not use a silencer diameter more than an inch to keep from covering the sights. So I am going to make a 1x4.5 inch can to keep muzzle blast down to a dull roar, and an extension that is 1.5x3.5 inches to further reduce the noise.
It wil be all aluminum except for the read end cap and blast baffle. Any suggestions?
I cut back the front sight and turned down the barrel for 1/2-28 threads. The revolver is shown with my 22lr silencer attached.
Ranb
I can not use a silencer diameter more than an inch to keep from covering the sights. So I am going to make a 1x4.5 inch can to keep muzzle blast down to a dull roar, and an extension that is 1.5x3.5 inches to further reduce the noise.
It wil be all aluminum except for the read end cap and blast baffle. Any suggestions?
I cut back the front sight and turned down the barrel for 1/2-28 threads. The revolver is shown with my 22lr silencer attached.
Ranb