m&p45acp10+1
New member
Ok I have been csting for a few days now. My 2 cavity Lee mold will not close complletly now. I am getting a line in my bullets. It is a raised edge that I can feel when I run my finger around the bullet. When I hold the mold up to light I can see light through it. I have tried cleaning the crap out of the mold blocks. I have re lubed them, if I tap them lightly they will line up and the light shining through is very minimal. Yet I still get the raised line.
Calling customer service of anywhere is very frustrating for me. I am legaly deaf so phone communication is difficult and frustrating. Emails usualy get some automated response that is not the info I wanted, nor needed.
I appreciate your responses and suggestions.
Nate
Calling customer service of anywhere is very frustrating for me. I am legaly deaf so phone communication is difficult and frustrating. Emails usualy get some automated response that is not the info I wanted, nor needed.
I appreciate your responses and suggestions.
Nate