Mossberg 930 -- Magazine capacity?

D

DouglasW

New member
Looking to pick up a Mossberg 930 for HD, but I'm a bit confused regarding their magazine capacity.




Mossberg's site states the HS model has a capacity of 5 rounds (4+1), the tactical has a capacity of 5+1 (though the magazines look the same length in the photo)...and the many glowing reviews here state the 930 SPX has a 7 round magazine, thanks to a Choate +2 extension. But 4+2=6 last time I checked, not seven. So how long is the magazine on the SPX without the Choate extension?

85320.jpg

85330.jpg



The reason I ask is that my wonderful city :mad: of Denver prohibits semi-auto shotties with a magazine greater than 6...so I'm trying to figure out how to get no more (and no less) than 6 rounds of 2 3/4 into a 930 SPX magazine...

Also, how difficult would it be to shorten the magazine of the SPX by removing the +2 and replacing it with a +1 from Choate? Would I just unscrew the +2 and screw on the +1 in it's place?

Thanks.
 
Here we go, again! Total capacity vs. magazine capacity. This has been confusing folks (myself included) since manufactures started being less specific in their ads and specs. You need to check your city ordinance very carefully. Like the Second Amendment, there are three things to consider: What did the city fathers originally mean; what does the ordinance actually say; and how do the local DA and courts interpret the ord.

We've all heard how the possession of a single part can get you busted under the feds broad interpretation of the NFA. Consequently, I'd avoid any aftermarket extension, trimmed or not. It might demonstrate your intent and capability to violate the ord.

If you really want to cover your back side, write a letter to the DA:
[SIZE=-2]
Dear _______,
I intend to purchase a _______ model__________ with a magazine capacity of _______. I understand this model is in compliance with all city ordinances enacted and pending as of this date. Is this correct?[/SIZE]​
Of course, if you're not concerned about a potential legal battle, go with your own interpretation and take a firm stand.
Good luck!
 
Mossberg made a mistake on their specs.

Fact: "All" 930 shotguns without a mag tube extension have 4+1 capacity.

A mag tube ext just screws on and off like the mag cap.



GC
 
Thanks for the replies, guys:

Max100 said:
Mossberg made a mistake on their specs.

Fact: "All" 930 shotguns without a mag tube extension have 4+1 capacity.

A mag tube ext just screws on and off like the mag cap.
Click to expand...

But if you're sure that the standard magazine only holds four (4) 2-3/4 shells....how are people getting 8 rounds (7+1) into their SPXs if the Choate extension is only a +2? :confused:

From an online review of the SPX:
The shotgun is able to chamber 2.75" and 3" shells. With 2.75" rounds the mag tube will hold seven rounds fully charged. With 3" shells this capacity drops to six. That totals out to either eight or seven total rounds, respectively.
Click to expand...
 
zippy13 said:
You need to check your city ordinance very carefully
Click to expand...

Thanks for your concern, Zippy. I've checked and double-checked the Denver ordinance Sec.38-130. "Assault weapons" (sic) and it clearly states that, within Denver, you may not possess:

Revised Municipal Code City and County of Denver said:
semiautomatic shotguns with a folding stock or a magazine capacity of more than six (6) rounds or both
Click to expand...
So it appears to me that a semi-automatic shotgun such as the 930 SPX with a fixed stock and a magazine capacity of 6 rounds (not magazine plus chamber) is completely legal.

Anyone interpret this differently?
 
930 SPX not for Devner

Oops....
The 930 SPX has a custom Choate 3-round extension!
From the Mossy catalog:
To put the "X" in SPX, Mossberg has installed a Choate magazine tube extension to the shotgun. This component takes the capacity to seven plus one in the chamber.

85360.jpg
 
zippy13 said:
930 SPX not for Denver
Click to expand...

I realize the stock SPX is no-go here. If I bought the SPX, I would change out the magazine extension for a +1 or +2 from Choate to bring the magazine down to a 6 round capacity.
 
limiter

inside my mossberg 500 was a dowel to limit the amount of ammo.
simply remove it or trim to your desired amount.
 
DouglasW

I'm on your side, but I'm playing devil's advocate...
Even with a standard 2 round extension (that complies), the factory specs say the mag capacity for a SPX is 7 and, I'm guessing, that's what the authorities would go buy.:mad:

tomgun
"inside my mossberg 500 was a dowel to limit the amount of ammo.
simply remove it or trim to your desired amount."​
A magazine plug (limiter) is acceptable in the enforcement of hunting regulations. However, since it's a temporary item, I doubt the anti "assault weapons" folks would accept it. Do you remember, during the 10-round limit era, high-capacity box mags that were "plugged" to 10-rounds had to be welded closed so you couldn't remove the plug?
 
DouglasW said:
I realize the stock SPX is no-go here. If I bought the SPX, I would change out the magazine extension for a +1 or +2 from Choate to bring the magazine down to a 6 round capacity.
Click to expand...

Be very careful.... Here in CT, sub-division (4) of the Assault Weapon definition states:
(4) A part or combination of parts designed or intended to convert a firearm into an assault weapon, as defined in subdivision (3) of this subsection, or any combination of parts from which an assault weapon, as defined in subdivision (3) of this subsection, may be rapidly assembled if those parts are in the possession or under the control of the same person.
Click to expand...

So....... here in CT, even if you make the shotgun compliant to the above arbritary rules, but you have all of the parts that can be assembles into an "assault wepon" you're still in violation of the law.... has nothing to do with intent.... check that Colorado lets you at least have the parts in the same location.
 
Hi Smitty.

I intend to be fully compliant with Denver's AWB, and would either sell the stock Choate mag extension -- perhaps to someone outside Denver who wishes to increase their HS model's magazine capacity -- or I might just mail it to my brother in Florida for safekeeping, in the unlikely case I move out of Denver or (even more unlikely) the laws here become less restrictive. :D

PM sent, too.
 
The 930 is a 4+1 capacity shotgun. The Choate tube ext on the SPX is a +3 no matter what Choate, Mossberg or anyone says. Moss 930 SPX 7+1 capacity.


GC
 
Just to clarify a bit more: The SPX, as delivered, does indeed hold 7+1 - 2 3/4" shells. However, if you go to buy the same extension from Choate to put on, say, a 930 Tactical, you want the "7 shot" extension. But they say in their description that it adds only 2 shell capacity to the gun. Actually, both statements are sort of true. The SPX utilizes the factory cup-type follower that comes on all 930's. But when you buy the extension from Choate, they send you a nice bright orange anti-tilt follower that has, of course, an anti-tilt extension that limits the compression of the spring a bit. If you use this follower, as I decided to, you will be just shy of being able to insert 7 - 2 3/4" shells in the tube. You will be able to get 6+1 capacity with 2 3/4" and 3" shells.

Of course, you can allways use the stock follower, but it has been shown vulnerable to tipping in some circumstances, when using the extended tube. Hope this helps and doesn't just add to the confusion.

ETA: The correct Choate part # for this extension is #02-04-32.
 
Last edited:
To address the OP more directly:

The reason I ask is that my wonderful city of Denver prohibits semi-auto shotties with a magazine greater than 6...so I'm trying to figure out how to get no more (and no less) than 6 rounds of 2 3/4 into a 930 SPX magazine...

Also, how difficult would it be to shorten the magazine of the SPX by removing the +2 and replacing it with a +1 from Choate? Would I just unscrew the +2 and screw on the +1 in it's place?
Click to expand...

If you replace the stock SPX follower with an anti-tip unit, the magazine will now only hold 6 rounds of either 2.75" or 3". If you buy the above mentioned Choate tube for a non-extended model, it will come with this part already. This should meet your requirements exactly. HTH
 
Want to know the easiest way to reduce the magazine capacity of a SPX by 1 is?



Just load it with Federal LE132-00 reduced recoil buckshot (other Federal rounds are probably the same). LE132's are about >.< that much longer than the standard 2 3/4 inch shell. It's not much but after six shells >......< it adds up and the 7th won't fit in a SPX magazine tube by less than 1/4 inch.



Want to know the easiest way to increase the magazine capacity of a SPX by 1 LE132-00 is?
Just replace the stock spring with one from a 590, it allows that 7th shell to fit in like it was made for the SPX.
 
Mossberg 930 SPX

Just went to a Dick's in New Jersey. In New Jersey a semi-auto shotgun can have no more than a six shell capacity.

What I saw looked different from the Mossberg SPX I once saw in a Dick's in Pennsylvania.

The one in Pennsylvania looked like a 20 inch barrel with a 7 or 8 shell magazine that went to the end of the barrel.

The one I saw in the New Jersey Dicks looked like an 18 inch barrel with a two shot extension that did not quite reach the end of the barrel for what I guess is a total of 6 shells in the magazine.

Does anyone have any info on this?

Thanks
 
The anti-tilt follower is a very easy install and prevents loading more than 6 rounds of any brand. It should satisfy any lawmakers as the gun cannot function if you remove the follower -- it's not just a spacer.
 
Expect the new Congress to reauthorize the so-called assault weapons ban and to limit semi-auto shotguns to 5-shot magazines.

Also, note that New Jersey outlaws the Ruger Mini-14 folding stock receiver. If the receiver has an "F" stamped on it it is contraband -- even if the receiver is mated to a plain vanilla non-folding stock!

I would be very careful about jiggering an SPX with a 3 shot extension to make it seem like a 2 shot extension.

I would only buy a 930 that left the factory with a 4 shot magazine and add a +1 or a +2 extension from Choate.

Be careful out there.
 
You must log in or register to reply here.
Back
Top