Mossberg 500 tang screw

[dakota.potts]

We bought a pistol grip Mossberg 500 a couple of months ago. We decided to change it into a Blackhawk! Compstock. Unfortunately, the grip screw that held the original grip in place is not long enough for the new stock. Does anybody know where I can get a longer one?

 

[Blindstitch]

The blackhawk website suggests the screw was pre installed or included with the grip. I would call or email them.

 

[Dreaming100Straight]

It looks to me like the instructions at the site say to use the original Mossberg bolt with the washer enclosed with the Blackhawk compstock. Use of 2 long a bolt can bust things all up.

 

[dakota.potts]

The problem is that the bolt is too short and the washer only makes the problem worse by making the adapter thicker requiring an even longer bolt.

I have to wonder if it's because I'm coming from a pistol grip and not stocked Mossberg

 

[idek]

http://www.gunpartscorp.com/Products/1126050A.htm

http://www.gunpartscorp.com/Products/46620A.htm

I believe these are the standard bolts.

Check their facebook page on Wednesdays for reduced shipping codes.

 

[Dreaming100Straight]

I have to wonder if it's because I'm coming from a pistol grip and not stocked Mossberg

Sounds like that is your problem if this is what your stock bolt looks like.

I think you need the one that idek linked you to. Did you download and look at the installation instructions?