You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Model 70
- Thread starter nighttime
- Start date
cntryboy1289
New member
not to my knowledge
I haven't seen a clip fed trigger plate for the model 70. You could do it yourself if you have the right tools and knowledge.
I haven't seen a clip fed trigger plate for the model 70. You could do it yourself if you have the right tools and knowledge.
Even in factory models, the integral mag/hinged floorplate model tends to be more foolproof and reliable. Unless the retrofit is done very well, it may not function reliably. I'd leave it as is...but YMMV. (For the record, I have bolt rifles both ways, and have never had a problem with the clip-fed rifles, but I have read lots of complaints here about them over the years.)
cntryboy1289
New member
e-GunParts.com
I was looking for some parts yesterday from Numrich. They did make a model 70 that cam with a detachable magazine. Look it up at their web site. Depending on the action length you have, you may be able to make this one work for you without having to change much on your gun other than cutting in the slots for the tabs to fit. Good luck with the project.
I was looking for some parts yesterday from Numrich. They did make a model 70 that cam with a detachable magazine. Look it up at their web site. Depending on the action length you have, you may be able to make this one work for you without having to change much on your gun other than cutting in the slots for the tabs to fit. Good luck with the project.