Miroku M92 bolt pin

[1100 tac]

Has any one here disassembled a late manufacture Miroku M92?
If so, how did you get the bolt pin out?

I have removed the screw cap from the left side and tapped with a small hammer
and punch from the right side, it ain't budging and I don't want to mess it up.
Are they usually very tight, or am I missing something? All of the searches and videos
that I have seen show this pin coming right out, but these have been on Rossi rifles.
I have checked with a strong flashlight and there is no screw slot like on the Chiappa's.

Any help is much appreciated.

 

[Scorch]

They are tight, but not that tight. You have to open the bolt to get the pin to line up.

 

[1100 tac]

Maybe on an '86, but not a '92.

 

[Dixie Gunsmithing]

If you are sure that you are striking the pin, and not part of the bolt, then I would put a little penetrating oil on it, let it sit, and then drive it out. You also have to remove the plug screw on the LH side (top one), for access to the pin.

 

[1100 tac]

The plug screw on the left is to let the pin come out from the right to the left, yes I have removed the plug screw. I can see the head of the pin through the plug screw hole.

This is a new rifle, but from time to time I want to be able to completely disassemble it for cleaning and lubrication, such as after shooting black powder.

Jerkwater at winchester/browning told me "No gunsmithing over the phone"

 

[Wyosmith]

This may help you.
Look at 5 minutes and 30 seconds for your particular problem.
https://www.youtube.com/watch?v=eNleCVMutuY

 

[1100 tac]

See post #1,,no screw slot...but thanks.