Machining for moonclips?

M

MrDontPlay

New member
Where is the best place to have my cylinder machined for moon clips and buy the moon clips? I've found two different places one milled them and one turned them on a lathe. I'm looking to have this done on a S&W 500 and possibly an SP101.
 
The 500 may be fine considering the sheer size ,but a 357 mag the cases get kinda wiggly lining up the holes.

I had the chance to try 1 out (GP100) & could beat my reload time with a HKS loader, I strongly suggest to try 1 before commiting if possible .
 
You must log in or register to reply here.
Back
Top