Had a few lee charge bars that I tried at first and could not get it to be consistent nor get low enough for what I was looking for. Was about to toss them (yes I have spares), when I decided to mess around with them a bit. A "new bar, I could only get Titegroup to throw consistant 5.0-5.1. Any further adjustments, and it would be light, then normal, then light etc. (light as in 1.5-2.0 gn).
What I did was take the auto disk hopper off, and sand down the top frame .005-.010" with 220 sand paper and a flat surface. (Piece of glass). Next, I sanded the charge bar top surface until it was flat. Yes, there where high spots.
The final adjustment was to the end of the adjustable bar. With a file, I added a bevel to the bar, and am now able to throw consistant 3.3 gn of Titegroup.
So, you can get the charge bar to throw below .4cc with a few minor adjustments.
What I did was take the auto disk hopper off, and sand down the top frame .005-.010" with 220 sand paper and a flat surface. (Piece of glass). Next, I sanded the charge bar top surface until it was flat. Yes, there where high spots.
The final adjustment was to the end of the adjustable bar. With a file, I added a bevel to the bar, and am now able to throw consistant 3.3 gn of Titegroup.
So, you can get the charge bar to throw below .4cc with a few minor adjustments.
